High Viscosity – Bonds most plastics rubbers, metals, woods, cork etc.

CA01 is High Viscosity ethyl-based superglue for bonding where gap fill is important, or where the materials are absorbent. CA01is versatile and will bond most plastics, rubbers and metals. Because of its viscosity CA01 allows additional bonding time prior to cure. Typical applications are ferrite cores, magnets, loudspeaker cones, leather trims, metal badges, and electronic components; however, will also bond cork, wood, ceramic, plastics etc. Only apply adhesive to one side. Apply pressure firmly for a few seconds until the bond forms. Allow to cure before putting into use.

Low Viscosity – Bonds elastomers, plastics, metals including electronic applications etc.

Ca24 is Modified Ethyl superglue which was specially developed for fast bonding of materials such as EPDM and difficult to bond elastomers. It is low viscosity superglue of 20cps. Speed cure is fast, usually in 2-7 seconds, depending on the type of material being bonded. Application varied, but mostly elastomer and plastics applications. Due to its rapid cure CA24 is ideal for fast repetitive on line applications, such as in electronics, plastic components assembly and rubber to metal bonds.

Hybrid / Surface Insensitive – Bonds woods, paper, cardboard, furniture, hobbyists etc.

CA41 is a Hybrid quality Cyanoacrylates which is surface incentive and bonds to a wide variety of materials including wood, paper, cardboard, leather fabrics etc. Bond times vary according to the substrates but are generally faster than normal superglues. Typical applications include wood trim on furniture, balsa wood bonding for hobbyists, leather accessories on shoes, fabric bows on shoes and lampshade bonding. Other features include versatile boning or most elastomers, metals and plastics. On elastomer bonding and some plastic, residues or release agents on surfaces should be removed by solvent wipe.

Low Viscosity / Surface Insensitive – Bonds neoprene, natural rubbers, metals, copper etc.

CA60, when compared to other Low Viscosity Cyanoacrylates, outperforms most products for cure speed, final cured strength and simply the wide range of difficult plastics and elastomers it can bond. For example, Nitrile, Neoprene and natural rubbers, plastics such as AB, soft PVC, Polyacetal, EPT and EVA can be bonded in 1-2 seconds and all the bonds are stronger than the material being bonded. Metals such as Steel, Aluminium, Copper and Brass all bond in under 5 seconds and the bond strengths are superior to other manufactures low viscosity products. Slower cures of up to 12 seconds are found on polymethyl Methacrylate (PMMA), Bakelite, Polycarbonate and Viton rubber. Polyolefin’s can be treated with special preparations

Extremely Strong / Rapid Cure Surface / Insensitive Adhesive

CA80 is a black modified, tough Cyanoacrylate with higher peel and shock resistance to other grades. Variety of bonding applications including, bonding rubbers and metals, but also acting as a strain relief in tough demanding environments. cA80 is designed for use with Activator AC113 to cure though gaps and large deposits or drop such as bridging and tacking/strain relief of components.

Paste-Non-Drip – Bonds leather, woods, metals, rubbers, plastics etc

CA44 is a thixotropic Gel or Paste-like superglue. It is a non-drop formulation and will not run on vertical surfaces. It is fast to set on difficult surfaces such as leather, acetic substrates and excellent for wood bonding, metals, rubbers, plastics etc. Where vertical surfaces with large gaps (up to 1mm with activator, 0.2mm without) are being bonded. CA44 Stays in place. When a fast cure is needed, our AC701 or the faster AC113 Activators will help cure the thickness and speed cure the adhesive, however, a reduction in ultimate bond strength will be found.